It was all pretty straight forward. The kit was made to be assembled with a bolt on neck all predrilled, so it was basically just shaping the body and headstock and then paint and varnish.
I did look up some painting techniques, but I really just wanted to stain the wood, so I did that with a brush and then 2 coats of varnish.
I had to sand the wood first to make it more open for staining instead of paint.
If you want to paint or spray paint you should probably keep or make a base coat to avoid the wood absorbing the paint.
It was a cheap stratocaster-like kit, so I wasn’t too concerned with making mistakes, but I’ll admit that putting the saw into a guitar was a little daunting at first.
I used a multi-cutter for most of it to make very precise cuts. And lots and lots of sandpaper by hand with different grit sizes.
It only took a few evenings to do, so it is not difficult at all, but I guess it depends on how much you want to customize it.
It was all pretty straight forward. The kit was made to be assembled with a bolt on neck all predrilled, so it was basically just shaping the body and headstock and then paint and varnish.
I did look up some painting techniques, but I really just wanted to stain the wood, so I did that with a brush and then 2 coats of varnish. I had to sand the wood first to make it more open for staining instead of paint. If you want to paint or spray paint you should probably keep or make a base coat to avoid the wood absorbing the paint.
It was a cheap stratocaster-like kit, so I wasn’t too concerned with making mistakes, but I’ll admit that putting the saw into a guitar was a little daunting at first.
I used a multi-cutter for most of it to make very precise cuts. And lots and lots of sandpaper by hand with different grit sizes.
It only took a few evenings to do, so it is not difficult at all, but I guess it depends on how much you want to customize it.