Hi there
The purpose of this schematic is to control a DC motor that runs at 8V max. That is why I chose 4 N-channel mosfets in the H bridge. P-channels would not fully activate at voltages above -10Vgs but the N-channels can handle 18V at the gate.
The 5v switches represent an Arduino’s digital output pins. One to turn forward, one for reverse. To prevent a failure scenario where both pins are HIGH I added a transistor that prevents current from flowing through the optocoupler on the second half bridge.
Does this circuit make sense? I’m not an electronics engineer, just a hobbyist and have doubts about how effective the gate driving circuit is of the mosfets.
Thanks!
Are you trying to run your motor at 5v? that’s what it reads to me.
If your current draw is under like 700ma, Consider a bridge driver like the L9110, it’ll get you the with minimal effort. There are other drivers out there as well. https://www.adafruit.com/product/4489
Between 4 and 8V. I’m driving a pump with a 12V rated 775 motor. Running it at full power makes the pump go too fast and with a lot of noise.
It’s kind of an overpowered motor for this project but I have a couple of spare ones.