I’ve tried to report the issue to Prusa support but they keeps trying to diagnose it as user error. But at this point I’m at a loss and presume that it’s either a firmware issue or a sensor issue on my unit.

Either way im very disappointed.

And before you ask, this is the opposite side

PXL_20240301_160413072

EDIT: I will note that this print sheet is ruined for my use case, since those patterns will be shown on the underside of my prints. But the print surface still works and can be used without issue… if you ignore the gouges that are being detailed into every print.

    • the16bitgamer@lemmy.worldOPEnglish
      5·
      9 months ago

      Print sheet works, cosmetically it doesn’t. I sell my prints, and having odd lines is not something I want to sell. I’m just disappointed since there was nothing I can do except watch and kill it as fast as I can.

    • brettvitaz@programming.devEnglish
      4·
      9 months ago

      I caution you to not put too much stock into OPs anecdotal experience. This is not a problem other people are having and is certainly not a firmware issue. I can say for certain that it has never happened for me.

    • grayman@lemmy.worldEnglish
      2·
      9 months ago

      Stuff sticks to my pei sheet TOO well. Clean it well… Soap and water with a new clean soft sponge. Get all the glue off and any other gunk and oil. Wipe it dry with a clean towel. Lightly rub it down with isopropyl alcohol. When dry, print on it with nothing on the sheet. I can go like 20 big prints before I have to clean it again.