- cross-posted to:
- linux@programming.dev
- cross-posted to:
- linux@programming.dev
You must log in or register to comment.
Trivia you can use to woo potential partners Here’s 443 pages on generic HID implementations.
My pants!
I would try doing this for my Intel WiFi/Bluetooth card that doesn’t support Linux (WiFi works anyway though). Since the CTRL key is dead (again) and the whole build of it is not to my liking I think I’ll get an old Windows 10 laptop to replace the whole system instead.
Found this to be an interesting read, and well written. Thanks for sharing it.
A very nice, simple webpage too.
I opened it and was immediately taken aback at how refreshing it feels to open a page that is entirely (mostly) just HTML/CSS.
Interesting read. I wonder where OP got the specs for the device itself, i.E. what it expects in terms of data and what the response (interrupt) values mean?
To my surprise, Nanoleaf tech support responded to me within 4 hours, with a full description of the protocol that’s used both by the Desk Dock as well as their RGB strips. The docs mostly confirmed what I had already discovered independently, but there were a couple of other minor features as well (like power and brightness management) that I did not know about, which was helpful.
Combo of investigating and a foot up from the manufacturer.
When I’ve done this in the past for game controllers I’ve not received such an emphatic response (other than when I was working for the vendor).
Did get some via FOI for a few other products though.
Over the past few posts I’ve set up a Windows VM with USB passthrough, and attempted to reverse-engineer the official drivers, As I was doing that, I also thought I’d message the vendor and ask them if they could share any specifications or docs regarding their protocol. To my surprise, Nanoleaf tech support responded to me within 4 hours, with a full description of the protocol that’s used both by the Desk Dock as well as their RGB strips.
