Just picked up an APC 48u server rack. There were no pictures of it in the post and I did not notice until I got it home and set up, that the rack rails have threaded holes instead of square cage nut holes. I can’t seem to determine the thread size and pitch, and have a thread gauge coming. Until then, does anyone know anything about this? The people I grabbed it from had used self tapping machine screws and drove them in with an impact wrench. Is this what APC had intended, or is there some $300 proprietary screw I have to buy from them?

  • Scrubbles@poptalk.scrubbles.tech
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I learned this the hard way, there is a difference between a “data rack”, which is the one with cage screws, and a “network rack”, which comes with the threaded machine screws. I believe switches have standardized screws

  • Saik0@lemmy.saik0.com
    link
    fedilink
    English
    arrow-up
    0
    arrow-down
    1
    ·
    1 year ago

    No idea on the screw question… but the labels are off by one screw spacing. The holes that are “close” are where the U labels should change.